Pbyp (Picture By Picture); Pinp (Picture In Picture) - Hitachi CP-X9110 User Manual

Operating
PbyP (Picture by Picture) / PinP (Picture in Picture)
The PbyP / PinP is a function for displaying two different picture signals on a
screen that is separated into main and sub areas for each signal.
PbyP
button
Press the PbyP button on the remote control. This acctivates the PbyP mode.
Then, press the PbyP button again. The projector goes into PinP mode. The
screen displayed before the PbyP button was pressed will be displayed as the
main area. Most of operations are effective for the main area only.
To quit the PinP mode, press the PbyP button again.
NOTE
• If the LAN port is selected when the PbyP button is pressed, input
from other port is displayed on the main area.
• When in the PbyP / PinP mode, use the MENU button on the remote control
or ▲/▼ buttons on the control panel to display the OSD menu.
• There are certain functions that cannot be used when in the PbyP / PinP
mode.
• A message will be displayed when buttons that cannot be used are pressed
(6). However, note that there are certain unusable buttons for which
messages are not displayed.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
(continued on next page)
44

Normal mode
main sub

area area
PbyP mode
main
area
sub
area
PinP mode only