Hitachi CP-X9110 User Manual page 22

Status Monitor
 In a normal state
The Status Monitor displays the state of the projector in
three lines.
: Displays the condition of the projector. While the lamp is on, the
1st line
selected port is displayed.
Displayed conditions are as below;
STANDBY: The projector is in standby mode.
WARM UP: The projector is warming up.
SEARCHING: The projector is searching an input signal.
COOL DOWN: The projector is cooling down.
: Displays the condition of the detected input signal while the lamp
2nd line
is on. Otherwise, displays the serial number of the projector.
Displayed conditions are as below;
SYNC OUT: Detected input signal is out of specified range.
NO SIGNAL: There is no input signal.
CONNECTED: The projector has connected to the network or the computer
HOLD: The projector has connected to the network but no image is transferred
while the LAN port is selected.
NOT CONNECTED: The projector is not connected to the network or the
: Displays supplied voltage and peripheral temperature in Celsius
while the lamp is on.
3rd line
NOTE
• While the projector is searching an input signal in normal condition,
nothing is displayed on the 2nd line of the monitor.
• Displayed temperature may be different from actual peripheral temperature
because the displayed temperature is measured inside the projector.
22
and some image is transferred to the projector while the LAN is
selected.
computer while the LAN port is selected.