Hitachi CP-X9110 User Manual page 77

Item
MyScreen Lock
OSD MESSAGE
(continued on next page)
Using the ▲/▼ buttons turns on/off the MyScreen lock function.
ON  OFF
When the ON is selected, the item MyScreen is locked. Use this
function for protecting the current MyScreen.
• This function cannot be selected when the ON is selected to the
MyScreen PASSWORD item in SECURITY menu (
Using the ▲/▼ buttons turns on/off the message function.
ON  SILENT  INHIBIT
■SILENT : The following message functions does not work.
"AUTO IN PROGRESS" while automatically adjusting
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"INVALID SCAN FREQ."
"NOT AVAILABLE"
"Searching...." while searching for the input
"Detecting...." while an input signal is detected
The indication of the ZOOM displayed by changing
*While operating from the remote control only.
The indication of the FOCUS displayed by changing
The indication of the input signal displayed by changing
The indication of the aspect ratio displayed by changing
The indication of the PICTURE MODE displayed by changing
The indication of the ACTIVE IRIS displayed by changing
The indication of the MY MEMORY displayed by changing
The indication of "FREEZE" and "II" while freezing the screen by
pressing the FREEZE button.
The indication of the TEMPLATE displayed by changing.
The indication of the ECO MODE displayed by changing.
■INHIBIT : All message functions does not work.
The only buttons will function are as below.
STANDBY, ON, SHUTTER, BLANK(MY BUTTOM), FUNCTION
Status Monitor can be operated.
• To change this function, follow the steps below.
1. Press the OSD button on the remote control for 3 sec.
2. The INHIBIT OSD will be displayed.
While this OSD is displayed, press the OSD button again on the
remote control.
3. Toggle and change the function.
ON  SILENT  INHIBIT
Description
SCREEN menu
94
).
77