Pbyp (Picture By Picture) - Hitachi CP-X10000 User Manual

PbyP (Picture by Picture)

The PbyP is a function to display two different picture signals on a screen that is
split in two areas for each signal. Some of functions can be used with the same
operation as it for the normal mode (not in the PbyP mode). There are some
operations available only in the PbyP mode.
Starting the PbyP
Press the PbyP PbyP button on the
remote control, then the PbyP
function will be started. To quit
the PbyP mode, press the button
again.
Showing the setting information
The setting information is displayed for several
seconds when the PbyP function is started. It shows
the input signal information for each area. Also, there
will be a yellow frame and speaker mark with one of the area that is the main area
where most of operations are effective. The information can be displayed using
the cursor buttons
Changing the main area
Most of operations are effective for the main area
only. Also the audio input signal paired with the
picture input signal for the main area is assigned
as the audio output signal. The main area can be
changed using the cursor buttons
setting information is on the screen.
Changing the picture input signal
Press the COMPUTER COMPUTER, VIDEO
while in the PbyP mode, the menu to select the
input signal will be appeared. Choose a signal using
the cursor buttons
the sub area, switch the main area using the cursor buttons
/ fi rst. Displaying the same signal on the both areas is
not allowed. For other combinations of the input signal, refer
to the right table. Any combinations marked with X can not be
selected.
Using the PbyP SWAP function
Press the MY BUTTON MY BUTTON assigned the PbyP SWAP
49). The position of the both area is exchanged
(
without any setting change.
NOTE •For some signals, it may not be displayed correctly in the PbyP mode,
even if it can be displayed properly in the normal mode.
/ / / when the setting information is not on the screen.
/
VIDEO or DIGITAL DIGITAL button
/ . If you want to change the signal in
FREEZE MENU
SHUTTER RESET
ASPECT
PbyP AUTO POSITION
when the
Operating
normal mode
setting information
main area
sub area
<signal combination>
Sub
Main
COMPUTER IN1 0
COMPUTER IN2 0
BNC 0 0
HDMI 0 0
DVI-D 0 0
Component 0 0
Scart RGB 0 0
S-Video 0 0
Video 1 0 0
Video 2 0 0
PbyP mode
main area
0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
0 0 0 0 0 0 0
0 X 0 X X X X
0 X 0 X X X X
0 0 0 0 0 0
0 X X X X X
0 X X 0 X X X
0 X X 0 X X X
0 X X 0 X X X
27