Pbyp (Picture By Picture); Pinp (Picture In Picture) - Hitachi CP-WU5500 User Manual

PbyP (Picture by Picture) / PinP (Picture in Picture)
The PbyP / PinP is a function for displaying two different picture signals on a
screen that is separated into main and sub areas for each signal.
MYBUTTON
INPUT
1 2
PbyP
ASPECT PbyP AUTO FREEZE
MYBUTTON
INPUT 1 2
ASPECT PbyP AUTO FREEZE button
MAGNIFY FOCUS ZOOM VOLUME
+ + +
ON
OFF - - -
PAGE
UP GEOMETRY PICTURE MUTE
MAGNIFY FOCUS ZOOM VOLUME
+ +
DOWN INTERACTIVE NETWORK BLANK ON
ESC MENU
ENTER
OSD MSG RESET
OFF
-
-
Press the PbyP button on the remote control. This acctivates the PbyP mode.
PAGE
UP GEOMETRY PICTURE MUTE
Then, press the PbyP button again. The projector goes into PinP mode. The
screen displayed before the PbyP button was pressed will be displayed as the
INTERACTIVE NETWORK BLANK
DOWN
main area. Most of operations are effective for the main area only. Only outputs
ESC MENU
the audio input signal paired with the picture input signal for the main area.
To quit the PinP mode, press the PbyP button again.
ENTER
NOTE
• If the LAN port is selected when the PbyP button is pressed, input
from other port is displayed on the main area.
OSD MSG RESET
• When in the PbyP / PinP mode, use the MENU button on the remote control
or ▲/▼ buttons on the control panel to display the OSD menu.
• There are certain functions that cannot be used when in the PbyP / PinP mode.
• A message will be displayed when buttons that cannot be used are pressed
(111). However, note that there are certain unusable buttons for which
messages are not displayed.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
(continued on next page)
+
Normal mode
-
main sub
ð
area area
PbyP mode
main
area
ð
PinP mode
Operating
sub area
47