Table of Contents
Advertisement
10-6. Electrical Characteristics (AC adapter)
(1) Input:
(2) Output:
(3) Current Consumption (DC 24 V at room temperature)
Standby:
ASCII printing:
100% print duty: Approx. peak 7.1 A
(Solid printing):
Note: Continuous solid printing should be 10 seconds or less.
(4) Slip printer current consumption (conditions: 24V, except when powering external
equipment)
Operating:
Continuous ASCII printing
Solid printing
(Solid printing)
MICR scanning
Note: When turning the power OFF and then ON again, there is a risk of a large surge cur-
rent flowing into the unit. Therefore, after turning the power OFF, wait a minimum
of 3 seconds before turning it back ON.
(5) Power Connector
Pin No.
1
Drive power (24 V)
2
3
Shell
Frame ground
Note:
• When using a printer power supply other than the optional AC adapter (PS60A-24A
series), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ± 5% and more than 2.0 A (5.0 A Load 10 sec. Min.)
with SELV output and LPS or Class 2 output approved by IEC60950.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.
100 to 240 V AC, 50/60 Hz
DC 24 V ± 10%
Approx. 0.1 A
Approx. average 2.2 A
Approx. average 4.1 A
Average approx. 1.3A
Average approx. 2.5A
Peak approx. 4.0A
Average approx. 1.5A
Function
Signal GND
N.C.
<Viewed from Connector Surface>
– 43 –
2
1
3
Advertisement
Table of Contents
