Table of Contents
Advertisement
3-2-2. RS-232C Interface Cable
(1) Make sure the printer is turn off.
CAUTION
Before connecting/disconnecting the interface ca-
ble, make sure that power to the printer and all the
devices connected to the printer is turned off. Also
make sure the power cable plug is disconnected
from the AC outlet.
(2) Connect the interface cable to the connector on
the rear panel of the printer.
(3) Tighten the connector screws.
3-2-3. USB Interface Cable
Affix the ferrite core onto the USB cable as shown in the illustration below and make sure to
pass the cable through the cable support as shown in the illustration.
Recommended Cable: 30729100 USB CABLE 1.8M TSP1
Ferrite core
4 cm (Maximum)
– 8 –
RS-232C
interface
cable
Advertisement
Table of Contents
