Auto Cutter Specifications; Interface; Electrical Characteristics (Ac Adapter) - Star TSP650 SERIES Hardware Manual

10-2. Auto Cutter Specifications

(1) Cutting Modes
(2) Cutting Duty
(3) Thickness of paper

10-3. Interface

RS-232C serial interface / Two-way parallel interface (IEEE1284)

10-4. Electrical Characteristics (AC adapter)

(1) Input:
(2) Output:
(3) Current Consumption (DC 24 V at room temperature)
Standby:
ASCII printing:
100% print duty:
(4) Power Connector
Pin No.
1 Drive power (24 V)
2
3
Shell Frame ground
Note:
• When using a printer power supply other than the optional AC adapter (PS60A-24A
series), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ± 5% and more than 2.0 A (5.0 A Load 10 sec. Min.)
with SELV output and LPS or Class 2 output approved by IEC60950.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.
Partial cut (leaves one uncut portion in center of paper)
Min. 3 seconds/cut
0.065 ~ 0.085 mm
100 to 240 V AC, 50/60 Hz
DC 24 V ± 5%
(Approx. 17.5% printing rate)
(Solid printing):
(Continuous solid printing should be 10 seconds or less.)
Function
Signal GND
N.C.
Approx. 0.15 A
Approx. average 1.7 A
Approx. peak 9.0 A
Approx. average 5.0 A
<Viewed from Connector Surface>
– 28 –