Table of Contents
Advertisement
3-7. Connecting to a Peripheral Unit
You can connect a peripheral unit to the printer using a modular plug. See "Modular plug" on
page 54 for details about the type of modular plug that is required. Note that this printer does
not come with a modular plug or wire, so it is up to you to obtain one that suits your needs.
CAUTION
Make sure that the printer is turned off and unplugged from the AC outlet and that the computer
is turned off before making connections.
(1) Make sure the printer is turned off.
(2) Affix the ferrite core onto the ethernet cable as shown in the illustration below.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it.
Use scissors to cut off any excess.
(5) Connect the peripheral drive cable to the connector on the rear panel of the printer.
CAUTION
Do not connect a telephone line into the peripheral drive connector. Failure to observe this may
result in damage to the printer.
Also, for safety purposes, do not connect wiring to the external drive connector if there is a
chance it may carry peripheral voltage.
Ferrite core
10 cm (maximum)
– 15 –
Peripheral drive cable
Pull and cut
Advertisement
Table of Contents
