Table of Contents
Advertisement
Levelling
You are recommended to use a spirit level on a shelf in the
oven to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker, turn the
adjusting nuts at the front bottom corners of the cooker.
To set the front feet turn the bases to raise or lower.
Fitting the Stability Bracket
A suitable stability device is shown in Fig.7-8 and Fig.7-9.
When using a stability bracket (Fig.7-8 and Fig.7-9), then
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Check the appliance is electrically safe when you have nished.
INSTALLATION
Stability bracket
23
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Outer stability
bracket
3 mm min
Wall
Typical wall mounting
Fig.7-8
Cooker
Floor
Fig.7-9
Cooker
Floor
Advertisement
Table of Contents
