Table of Contents
Advertisement
Positioning the Cooker
The diagrams show the minimum recommended distance
from the cooker to nearby surfaces (Fig.7-1 and Fig.7-2).
The cooker should not be placed on a base.
The hotplate surround should be level with, or above,
any adjacent work surface. A gap of 75 mm should be left
between each side of the cooker ABOVE the hotplate level
and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 800 mm is required between the top of
the hotplate and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
**Any splashback must be tted in accordance with the
manufacturers instructions. Allowance should be made for the
ue trim, which is tted to the cooker hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
cooker to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
We recommend a gap of 905 mm between units to allow for
moving the cooker. If a ush t is required, t the cooker up
to the unit at one side then t the unit the other side. Do not
box the cooker in – it must be possible to move the cooker in
and out for cleaning and servicing.
If the cooker is not installed between units, a side panel
extension that closes the gap to the wall at the rear is
available as an optional extra kit.
Moving the Cooker
On no account try and move the cooker while it is
n
n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n
n
We recommend two people manoeuvre the cooker. Make
sure that the oor covering is rmly xed, or removed to
prevent it being disturbed when moving the cooker around.
To help you, there are two levelling rollers at the back and
two screw-down levelling feet at the front.
Removing the Drawer
Pull the drawer right out.
Push the ends of the plastic clips – down on the left-hand
side, up on the right-hand side – to release the catches
holding the drawer to the side rails (Fig.7-3). At the same
time pull the drawer forwards and away from the side rails.
For safety reasons push the drawer runners back out of the
way and put the drawer somewhere safe until the installation
is complete.
Check the appliance is electrically safe when you have nished.
INSTALLATION
ArtNo.092-0006 - 900S DF min positions above cooker
410 mm min
2.5 mm
21
75mm
min
800mm
min
2.5mm
900mm
900 mm min*
**
Fig.7-1
75mm
min
912mm min
937mm max
2.5mm
Fig.7-2
2.5 mm
Fig.7-3
Advertisement
Table of Contents
