Table of Contents
Advertisement
8
Preparing the stove for rear outlet
To connect the flue pipe, remove the cover plate as follows:
Tilt the cover plate back and forth a couple of times to release and
remove.
Loosen the internal cover (boiler plate) from the inside and remove.
You will need this plate later as a seal and a cover for the top outlet.
Attach the loose collar from the outside and use the enclosed fit-
tings and the seal from the service package to fix in place.
Insert the cover plate into the hole in the top plate.
A S S E M B LY
Fresh air intake
In a well-insulated house, the air used up by the burning process has
to be replaced. This particularly applies to houses with mechanical
ventilation. There are different ways of making sure that an air
exchange takes place. The most important thing is to ensure that
there is a supply of air to the room where the wood stove is located.
The external wall vent must be located as close to the wood stove
as possible, and you must be able to close it when you are not using
the wood stove.
There are two kinds of air supply:
Air that enters the room from outside (fresh-air connection piece).
Air that is led directly into the stove's combustion chamber (external
combustion air).
National and local building regulations must be followed with
regard to the connection of fresh-air intake.
Fitting the fresh air connection piece
The Scan 53 can be connected to a fresh air connection piece bought
from a Scan dealer. Fit this as shown below.
Closed combustion system
You should use the closed combustion system for the wood-burning
stove if you live in a newly-built, airtight home. Outside air for
combustion is connected through a ventilation pipe via the wall or
floor.
It must not be possible to shut off the ventilation pipe with a valve
•
Minimum Ø100 mm ventilation pipe, maximum length: 6 m
with a maximum of one bend
Hide quick links:
Advertisement
Table of Contents
