Unpacking; Service Package; Accessories; Assembly - SCAN 53 Assembly And Instruction Manual

Type plate

All Scan wood-burning stoves are fitted with a type plate, that
specifies the approval standards and the distance to flammable
materials.
Scan 53
Freestanding room heater fired by solid fuel
Standard: EN 13240
Minimum distance to combustible materials:
Side: 400 mm - Back: 200 mm - Front: 800 mm
CO emission at 13% O2:
Dust CO emission at 13% O2:
Flue gas temperature:
Nominal heat output:
Efficiency:
Fuel type:
Operation type:
The appliance can be operated in a shared flue.
Country Certificate/Standard
Classification
EUR
Intermittent
SINTEF 043-057
Norway y Klasse 2
Austria
Schweiz LRV 11
VKF
Germany y BStV 1 FSPS-Wa 1419-EN
Angaben für Österreich
Wärmeleistungsbereich:
Brennstoffwärmeleistung:
Zulässige Brennstoffe:
Prüfbericht:
Follow assembly- and instructions for use.
Use only recommended fuels.
Montage- und Bedienungsanleitung beachten.
Verwenden Sie nur empfohlene Brennstoffe.
1000 Scan A/S DK 5492 Vissenbjerg Scan A/S DK 5492 Vissenbjerg

Unpacking

We recommend that you leave the protective film on the stove until
fitting is complete.

Service package

The service package contains the following:
• Fitting for flue collar
• Seal for flue collar
• Safety fitting
• Plastic plugs for transport safety hole at the bottom of the
stove
• Various tools
• Glove
• Fire starters for first lighting

Accessories

• Shaped floor plate in steel or glass
• Glass top plate
• Front shelf in glass, steel or stainless steel
• Fresh-air box, external combustion air
• Fresh-air connection piece
A S S E M B LY
EC no. 90053600
0,10% 1209 mg/Nm³
42 mg/Nm³
290°C
7 kW
79%
Wood
Intermittent
Approved by pp y
EN 13240
RWE Power AG
SINTEF - NBL
15 a B-VG DMT
N 13088 RWE Power AG
RWE Power AG
3,5 - 7,0 kW
8,3 kW
Scheitholz
RO-91 03 451
04-2009

Load bearing underlay

All of the products in our portfolio are classified as light-duty fire-
places; in most cases, there is no need to reinforce the floor, so that
you can typically use the normal floor.
However, you should make sure that the load bearing underlay
can bear the weight of the wood-burning stove and that of the
chimney.

Floor plate

If you are setting up the stove on a flammable floor, observe natio-
nal and local regulations on the size of the non-flammable underlay
that covers the floor around the stove.
Your local Scan dealer can advise you on regulations concerning
flammable materials in the vicinity of your stove.
The idea behind the floor plate is that it protects the floor and flam-
mable material against sparks.
The floor plate can be made of steel or glass, and the stove can be set
up on brick, natural stone or similar materials.
This Scan wood-burning stove has an integrated floor plate, and
can thus be set up on any flammable material without a protective
underlay.
If you are using a shaped floor plate, you should adjust the stove
upwards to allow the plate to be inserted under the front of the
stove.
5