Assembly; Tools Needed For Mounting Of The Stove; Loose Parts; Additional Accessories - SCAN 67 Assembly And Instruction Manual

ASSEMBLY

TOOLS NEEDED FOR MOUNTING OF THE STOVE

¬ Spirit level
¬ Cutting nippers

LOOSE PARTS

In the stoves combustion chamber you will find the following loose parts:
¬ Glove
¬ Seal for the connecting piece
¬ USB-C charger cable for Zensoric control

ADDITIONAL ACCESSORIES

¬ Small shaped floor plate in glass
¬ Scan 67 1300 cm: Heat accumulating stones
(2 items approx. 21 kg)
¬ Handle - 7 different kinds

DISPOSAL OF PACKAGING

Your Scan stove may come supplied with the following packaging:
Wood packaging
Foam
Plastic bags
Stretch/plastic film

FRESH AIR INTAKE

In a well-insulated house, the air used up by the burning process has to be replaced. This particularly applies to houses with
mechanical ventilation. There are different ways of making sure that an air exchange takes place. The most important thing is to
ensure that there is a supply of air to the room where the wood stove is located. The external wall vent must be located as close
to the wood stove as possible, and you must be able to close it when you are not using the wood stove.
National and local building regulations must be followed with regard to the connection of fresh-air intake.
The wood packaging can be reused and after final use can be incinerated as a CO
product or sent for recycling
Send for recycling or waste disposal
Send for recycling or waste disposal
Send for recycling or waste disposal
¬ Combo wrench 8 mm
¬ 3 allen keys (2,5 mm, 4 mm & 5 mm)
¬ Connecting piece 148 cm for outside flue pipe
¬ Dekor plate for top plate
¬ Eco energy label
¬ Large shaped floor plate in glass
¬ Scan 67 1600 cm: Heat accumulating stones
(5 items approx. 52,5 kg)
neutral
2
9