Table of Contents
Advertisement
ASSEMBLY
TOOLS NEEDED FOR MOUNTING OF THE STOVE
¬
Spirit level
¬
Cutting nippers
LOOSE PARTS
In the stoves combustion chamber you will find the following loose parts:
¬
Glove
¬
1 flue connection piece 180 mm (int. flue pipe)
¬
Seal for the connecting piece
¬
Top back plate
¬
Baffle plates
¬
Slingbar
ADDITIONAL ACCESSORIES
¬
Small shaped floor plate in glass
¬
Heat accumulating stones (6 items approx. 100 kg)
¬
Fresh air adapter rear (wall-hung)
DISPOSAL OF PACKAGING
Your Scan stove may come supplied with the following packaging:
Wood packaging
Foam
Plastic bags
Stretch/plastic film
FRESH AIR INTAKE
In a well-insulated house, the air used up by the burning process has to be replaced. This particularly applies to houses with
mechanical ventilation. There are different ways of making sure that an air exchange takes place. The most important thing is to
ensure that there is a supply of air to the room where the wood stove is located. The external wall vent must be located as close
to the wood stove as possible, and you must be able to close it when you are not using the wood stove.
National and local building regulations must be followed with regard to the connection of fresh-air intake.
The wood packaging can be reused and after final use can be incinerated as a CO
product or sent for recycling
Send for recycling or waste disposal
Send for recycling or waste disposal
Send for recycling or waste disposal
¬
Combo wrench 10 mm
¬
3 allen keys (2,5 mm, 4 mm & 5 mm)
¬
1 connecting piece for fresh air inlet
¬
1 flue connection piece 190/200 mm (int./ext. flue pipe)
¬
Dekor plate for top plate
¬
Screw M5x16 mm (Only used in Norway)
¬
2 pins for baffle plates
¬
Large shaped floor plate in glass
¬
Cleansing lid for rear outlet
neutral
2
9
Advertisement
Table of Contents
