Access Options; Access Via Serial Interface; Access Via Serial Connection - Funkwerk bintec R230a User Manual

Windows
ToDo
Access and Configuration
2

Access Options

In the following chapter you will find a description of the different access
options. Please select the option that fits best to your convenience.
For the configuration of your gateway you have the following access options:
■
via the serial interface
■ ➤➤
via your LAN (page
2.1

Access via Serial Interface

Each bintec gateway is equipped with a serial interface at which you can
setup a direct connection to a PC. The following chapter describes what
to observe when setting up a serial connection and how to configure the
gateway.
2.1.1

Access via Serial Connection

Access via serial interface is recommended if you like to create the initial
gateway configuration and if a LAN connection is not possible via the pre-
configured IP address (192.168.0.254/255.255.255.0).
Please follow the instructions in the Quick Install Guide to connect your gate-
way to your PC via serial interface. The printed version of the Quick Install
Guide is included in the gateway delivery size. Additionally, you can find the
electronical version on the
If you use a Windows-PC for setting up the serial connection a terminal program
is required, e.g. HyperTerminal. Please check whether HyperTerminal was in-
stalled during the Windows installation. You can also use any other terminal
program that can be adjusted to the respective parameters (see below).
If you have installed BRICKware
links are provided. If you use these for the serial connection of your gateway,
you do not need to specify any settings.
(page 7)
9)
Companion CD.
as described in the Quick Install Guide, two
2
Access Options
bintec User's Guide 7