Ascii Version - Funkwerk bintec R230a User Manual

4
Configuration Options
18 bintec User's Guide
LAN at its preconfigured IP configuration. The
ers all standard configurations.
If you would like to adjust further settings, you can select one of the other con-
figuration options mentioned above. You can first configure your gateway with
the HTML Wizard
of the other options. The mere configuration with the
normally is sufficient.
The Wizard guides you through the steps of the gateway configuration. After
completion of the Wizard sequence your gateway is ready for operation. The
data you need to enter during the Wizard run as well as the prerequisites for
configuration are described in the Quick Install Guide (printed version also in-
cluded in delivery size).
Open issues can be clarified by means of the comprehensive help system of the
Wizard. Therefore, the Wizard is not described in this chapter in detail.
4.1.1

ASCII Version

If you cannot access your gateway via your LAN or cannot start the
Wizard for any other reason, you can start the ASCII version of the Wizard
on the SNMP shell. Thus you can use all features of the Wizard via a serial
connection.
ToDo You can start the ASCII version of the Wizard with all available types of connec-
tion: connection to the gateway via LAN or via serial connection. Log in as
admin and access on SNMP shell is required.
Take the following steps:
1. Log in to the gateway as admin
2. After the command prompt enter wizard and press Enter.
The ASCII version of the Wizard starts. In this version all configuration options
of the HTML version are available. The help texts can be opened by selecting
the HELP menu.
and then extend or modify the initial configuration using one
(see "Login for Configuration" on page
HTML Wizard normally cov-
HTML Wizard, however,
HTML
14).
Access and Configuration