Variable Programs; Copying Programs - Pfaff 3119 Instruction Manual

11

Variable programs

.05
39 variable programs can be stored in the machine. A variable program can be selected with
the program number 1 to 39.
Variable programs can be created by copying and altering the desired parameters of an
existing program or by entering completely new parameters.
11

Copying programs

.05.01
If there is a program in the machine which corresponds approximately to the required pro-
gram, this can be copied and then altered. This method is particularly suitable if e.g. only one
parameter has to be altered, to achieve the desired result.
● Switch on the machine.
4200
+
● Select the fixed or variable program to be copied with the corresponding plus/minus key
-
using the cut length or program number (e.g. P2).
● Select the operational mode Input (LED in the key is off).
● Select function group "200" using the corresponding plus/minus key.
200
● Confirm the input with Enter.
● Enter the code, see Chapter 11.03 Entering/altering the access code.
201
+ ● Select parameter "206" (copying program) with the corresponding plus/minus key and
confirm with Enter. . . . . On the display the next free program number appears after the
-
parameter (variable programs from 1 – 39).
206
● Confirm the input with Enter.
The next steps for altering the program are described in Chapter 11.05.02 Creating/
modifying variable programs.
P2 500
+ +
- -
+ +
- -
+ +
- -
3
+ +
- -
Input
11 - 5