Adjustment
13
Catch
.34
● Connect the machine to the compressed air system and switch on the machine at the
● Move through the seam construction step by step until the cutter frame 1 is at the
● Adjust catch 3 ( screw 4 ) according to the requirement.
● Move the machine further until reaching the basic position.
● Switch off the on/off switch and disconnect the machine from the compressed air system.
13 - 33
Requirement
When the cutter frame 1 is at the highest point of the cam guide unit 2, there should be a
space of 0.2 mm between catch 3 and pawl 6.
4 6
3
Fig. 13 - 30
on / off switch.
highest point of the cam guide unit 2.
6
1
2
3
56-038b