Sewing
10
Selecting the cut length of the buttonhole
.04
In general the cut length of the buttonhole is defined by the size of the knife installed.
With the "multiple cut" function it is possible to make larger buttonhole cut lengths.
Activating the multiple cut function
● Switch on the machine.
● Select the operational mode Input (LED in the key is off).
+
● Select the function group, e.g "200", with the corresponding plus/minus key.
-
● Confirm the input with Enter.
● Enter the code, see Chapter 11.03 Entering/altering the access code.
+
● With the corresponding plus/minus key select e.g. parameter "207" (multiple cutting).
-
+
● Activate the multiple cutting function with the corresponding plus/minus key.
-
● The knife length and cut overlap must then be entered.
10 - 4
To avoid premature wear of the cutting equipment we recommend the use of a
knife matching the buttonhole length.
200
+
-
201
+
-
207
+
-
207
+
-
+
-
+
-
I
+
-
II
+
-