Pfaff 3119 Instruction Manual page 107

Group Parameter Meaning
2 206 Copy programs
207 Multiple cutting OFF = I, ON = II
208 Enter knife and cut overlapping length of
the fitted knife
209 Double cycle (stitch divisor)
1 = full no. of stitches per cycle
2 = half no. of stitches per cycle
stitch offset from 1
210 Knife release for multiple cut after "cut on" 0.0 – 5.0
Knife release for single cut after "cut off"
211 Number of securing stitches
3 301 Program number
302 Cut length (mm)
303 Buttonhole model
304 Distance of left purl seam from centre of
cutting line = distance A (mm)
305 Width of left purl seam = width A (mm)
306 Length of left purl seam (same length as
right purl seam) = length A (mm)
307 Number of stitches in left purl seam
= number of stitches A
308 Secondary thread tension left purl seam
(II = on; I = off)
309 Width of 1
310 Second width of 1
311 Length of 1
312 Second length of 1
313 Number of stitches in 1
= number of stitches B
314 Distance of 1
= distance B (mm)
315 Secondary thread tension of 1
(II = on; I = off)
316 Distance of right purl seam from cutting line
(needle penetration left) = distance C (mm) -2.0 to 2.0
st to 2 nd cycle
st bar = width B (mm)
st bar = width B1 (mm)
st
bar = length B (mm)
st bar = length B1 (mm) 0.0 – 6.0
st bar
st bar to centre of cutting line
st bar
Adjustment
Setting Standard value
- -
I, II I
6.4 – 38.1 6.4
0.0 - 4.0 0.0
1.2 1
0.0 – 2.0 0.3
0.5
0.0 – 5.0 1.6
1 – 3 1
1 – 39 1
6.4 – 38.1 12.7
1 – 31 1
-2.0 to 2.0 0.2
0.5 – 5.5 1.5
1.0 – 48.0 14.8
1 – 255 32
I, II I
1.0 – 5.5 3.4
0.0 – 5.5 0.0
1.0 – 6.0 1.2
0.0
1 – 99 8
-2.0 to 2.0 0.0
I, II II
0.2
13 - 50