Setting Up The Machine Control Unit; Establishing The Sub-Class - Pfaff 3119 Instruction Manual

Installation and commissioning
8

Setting up the machine control unit

.04
After the initial machine start up, first of all the allocation of the machine control unit to the
machine sub-class being used must be checked and adjusted if necessary.
8

Establishing the sub-class

.04.01
8 - 5
1
Fig. 8 - 05
Work clamp cut-out
30,0 x 5,6
40,0 x 5,6
40,0 x 6,7
44,0 x 6,7
46,0 x 6,7
55,0 x 7,0
Measure the size of the cut-out in the
work clamp 1.
With the cut-out size and the aid of the
following table, the sub-class and the
parameter value "202" can be established.
How to set parameter "202" is described
in Chapter 8.04 Setting parameter
"202".
Sub-class Value for parameter "202"
3119-1/51, -1/52
3119-2/51
3119-2/53
3119-2/63
3119-3/51
3119-4/51
1
2
3
3
4
5