To Transfer A Call; Conference; Call Pickup (Group) - NEC Dterm Series I Quick Reference Manual

NOTE: Any station with this line appearance can retrieve the call.
If unanswered
After preprogrammed time, Automatic Recall is initiated.
Visual and audible signal (rapid flash and ring burst) is sent to station that placed call on hold.
NOTE 1: A transfer or conference call may be placed on hold depending on software level of the
switch.
NOTE 2: Hold shows as a flashing green LED on your phone. The same line on other phones shows
as a flashing red LED.
other phones with the same line.

TO TRANSFER A CALL

After conversing, ask party to hold.
Press Transfer. Receive interrupted dial tone.
Dial destination station's extension, hang up or wait for answer.
If transferring party hangs up, that station's number appears in
the center of recipient's display.

CONFERENCE

With call in progress, ask party to hold.
Press Transfer, receive interrupted dial tone.
Dial desired number.
After call is answered, press
Three-way conference is established.
If one party hangs up, other two remain connected.
Using the Soft Key
With a call in progress, press
After call is answered, press
CONF Soft Key. Three-way conference is established.

CALL PICKUP (GROUP)

When station within pickup group rings:
Lift handset.
Press CALL PICKUP
Connection to calling party is established.
If currently on a call, press
hold.
Using the Soft Key
Lift handset and press
Recall shows as a flashing green LED on your phone and flashing red LED on
Conf. Conf LED lights.
Transfer and dial desired number.
or dial Call Pickup access code (may be stored on-one-touch speed calling key).
Transfer and dial Call Pickup access code. The original party is placed on
PICK Soft Key.
Conf LED goes out.
3