Pilot And Canopy Installation - Hangar 9 YAK 54 89 Assembly Manual

Pilot and Canopy Installation

Required Parts
• Fuselage
• Instrument panel decal
• Canopy hatch
Required Tools and Adhesives
• Hobby knife
• Phillips screwdriver: #1
• Rubbing alcohol
• 30-minute epoxy

Step 1
Use a hobby knife to trim the instrument panels from
the decal sheet. Note there is a front and rear instrument
panel decal.

Step 2
Remove the backing and secure the instrument panels into
position in the canopy hatch.
• Pilot figure
• Canopy
• Canopy glue
• Sandpaper
• Paper towel
• Painter's tape

Step 3
Remove a section of the covering from the canopy hatch
from under where the pilot will sit. Use 30-minute epoxy
to secure the pilot in the cockpit.

Step 4
Once the epoxy has fully cured, check that the screws
holding the visor of the pilot are tight.
27