Section 1: Installing The Tail Section - Hangar 9 Twist Plug-N-Play Assembly Manual

Section 1: Installing the Tail Section

Required Parts
• Stabilizer assembly
• Rudder assembly
Required Tools and Adhesives
• Crescent wrench
• 4-40 lock nut (2)

Step 1
Loosen the nuts on the bottom of the fuselage that are
holding the rudder/fin assembly onto the fuselage. Pull
the rudder/fin assembly straight up to remove from the
fuselage. Use care not to damage the lower portion of the
fin or the fuselage fairing.
• Fuselage
• Threadlock
• #4 washer (2)

Step 2
Locate the stabilizer/elevator assembly. Position the
stabilizer/elevator assembly so the control horn will face
down, away from the fin. The threaded rods from the
rudder/fin assembly will slide into the two holes in the
stabilizer. The fuselage fairing has been slid into position
on the fin in the photograph.

Step 3
Slide the rudder/stabilizer assembly onto the fuselage.
Slide the #4 washers onto the threaded rods. Apply a drop
or two of threadlock to the exposed threads of the threaded
rods. Thread the nuts onto the rod, tightening them snugly
against the bottom of the fuselage.
5