Lexmark X646ef Menus And Messages Manual page 123

Message
293 Replace all
originals if restarting
job.
293 Replace jammed
originals if restarting
job.
294.00 Scanner jam,
remove all originals
from the scanner
294.00 Scanner jam,
remove jammed originals
from the scanner
294.01 Scanner jam,
remove all originals
from the scanner
294.01 Scanner jam,
remove jammed originals
from the scanner
298.01 Scanner Missing –
Cable Unplugged
298.02 Scanner Missing –
Cable Unplugged
Understanding MFP messages
Meaning
The MFP receives a scan job;
however, there is no original
document in the ADF.
Job level recovery is active.
The MFP receives a scan job;
however, there is no original
document in the ADF.
Page level recovery is active.
The scanner detects a jam at the ADF
exit sensor while the scanner is idle.
Job level recovery is active.
The scanner detects a jam at the ADF
exit sensor while the scanner is idle.
Page level recovery is active.
The scanner detects a jam at the ADF
exit sensor while the scanner is idle.
Job level recovery is active.
The scanner detects a jam at the ADF
exit sensor.
Page level recovery is active.
The MFP detects after powering on
that the front side scanner cable is
unplugged.
The MFP detects after powering on
that the back side scanner cable is
unplugged.
Attendance messages
123
Action
Touch Continue if no scan job is active when
the attendance message appears. This clears
the message.
Touch Cancel Job if a scan job is processing
when the attendance message appears. This
cancels the job and clears the message.
Touch Scan from Automatic Document Feeder
if the page jam recovery is active. Scanning
resumes from the ADF immediately after the
last successfully scanned page.
Touch Scan from flatbed if page jam recovery is
active. Scanning resumes from the flatbed
immediately after the last successfully scanned
page.
Touch Finish job without further scanning if
page jam recovery is active. The job ends at the
last successfully scanned page, but the job is
not canceled. Successfully scanned pages go
to their destination: copy, fax, e-mail, or FTP.
Touch Restart job if job recovery is active and
the job is restartable. The message clears. A
new scan job containing the same parameters
as the previous job starts.
Remove all original documents from the ADF to
clear the jam. The message clears.
Remove all original documents from the ADF.
The message clears.
Remove all original documents from the ADF to
clear the jam. The message clears.
Remove all original documents from the ADF.
The message clears.
1 Turn the MFP off.
2 Plug the front side scanner cable into its
connector.
3 Turn the MFP on.
1 Turn the MFP off.
2 Plug the back side scanner cable into its
connector.
3 Turn the MFP on.