Lexmark X646ef Menus And Messages Manual page 111

Message
Replace all originals if
restarting job.
Replace jammed originals
if restarting job.
Replace wiper
Restore held jobs?
Understanding MFP messages
Meaning
One or more messages that
interrupted a scan job are now
cleared. Replace the original
documents in the scanner to restart
the scan job.
One or more messages that
interrupted a scan job are now
cleared. Replace the original
documents in the scanner to restart
the scan job.
The MFP detects that the fuser wiper
needs to be replaced.
Held jobs are found on the hard disk
after a power-on reset of the MFP.
Attendance messages
111
Action
Touch Restart job if job level recovery is active
and the job is restartable. The message clears.
A new scan job containing the same parameters
as the previous job starts.
Touch Cancel Job if a scan job is processing
when the attendance message appears. This
cancels the job and clears the message.
Touch Scan from Automatic Document Feeder
if the page jam recovery is active. Scanning
resumes from the ADF immediately after the
last successfully scanned page.
Touch Scan from flatbed if page jam recovery is
active. Scanning resumes from the flatbed
immediately after the last successfully scanned
page.
Touch Finish job without further scanning if
page jam recovery is active. The job ends at the
last successfully scanned page, but the job is
not canceled. Successfully scanned pages go
to their destination: copy, fax, e-mail, or FTP.
Touch Restart job if page level recovery is
active and the job is restartable. The message
clears. A new scan job containing the same
parameters as the previous job starts.
Touch Cancel Job if a scan job is processing
when the attendance message appears. This
cancels the job and clears the message.
Touch Scan from Automatic Document Feeder
if the page jam recovery is active. Scanning
resumes from the ADF immediately after the
last successfully scanned page.
Touch Scan from flatbed if page jam recovery is
active. Scanning resumes from the flatbed
immediately after the last successfully scanned
page.
Touch Finish job without further scanning if
page jam recovery is active. The job ends at the
last successfully scanned page, but the job is
not canceled. Successfully scanned pages go
to their destination: copy, fax, e-mail, or FTP.
1 Replace the fuser wiper.
2 Touch Continue to clear the message.
Touch Ignore to clear the message, but at the
next power-on, the message appears again.
Touch Yes to restore the held jobs to the hard
disk and make them available. The jobs data
remains on the hard disk; however, the job
control information is stored in the MFP
memory. Touch Quit to stop restoring held jobs
before all jobs are restored. Unrestored jobs
remain on the hard disk and are retrievable
again only at the next power-on reset.
Note: A pop-up screen appears to indicate
Restoring held jobs(s) xxx/yyy, where xxx
indicates the number of the current job being
restored, and yyy is the total number of jobs to
be restored.
Touch Do not restore to have the held jobs
remain on the hard disk until they are deleted.