Chapter 2: Understanding Mfp Messages; Status Messages - Lexmark X646ef Menus And Messages Manual

2
Understanding MFP messages
Messages appear on the MFP control panel describing the current state of the MFP and indicating possible MFP problems
requiring intervention.

Status messages

Status messages provide information on the status of the MFP.
Message
Bin [x] Full
Busy
Flushing Buffer
Hex Trace
[linked set bin
name] Full
Maintenance
Network
Network [x]
Network [x], [y]
Parallel
Parallel [x]
Serial [x]
USB
USB [x]
[PJL RDYMSG]
Meaning
x represents the number of the
output bin that is full when the MFP
bins are linked.
The MFP is busy receiving,
processing, or printing data.
The MFP flushes corrupted data and
discards the current print job.
The MFP is in Hex Trace mode.
Hex Trace isolates the source of a
print job problem. When Hex Trace is
active, all data sent to the MFP prints
in hexadecimal and character
representation.
The linked set of bins with a
previously defined name is full.
The MFP maintenance counter has
exceeded its limit, so the MFP
requires maintenance.
A network interface is the active
communication link.
A parallel interface is the active
communication link.
A serial interface is the active
communication link.
The MFP is processing data through
the specified USB port.
This is the Printer Job Language
(PJL) Ready message.
Understanding MFP messages
Action
Remove print media from the bins. The message
clears once the output level of the linked bins is no
longer full.
Note: The message appears on the Menu Settings
Page also. See Menu Settings Page for more
information.
Press Stop to access the job queue.
Exit Hex Trace to print jobs normally. To exit Hex
Trace, unplug the MFP.
Remove print media from the bins. The message
clears once the output level of the linked bins is no
longer full.
Note: The message appears on the Menu Settings
Page also. See Menu Settings Page for more
information.
Replace the maintenance items. If necessary, reset
the MFP maintenance counter.
Wait for the message to clear.
Notes:
• The current interface appears on the Menu Settings
Page. Interfaces shown without an x or y means the
active host interface is a standard interface.
• x indicates the active interface is connected to the
MFP through PCI connector x.
• x, y indicates the active interface is connected to
the MFP through channel y on PCI connector x, or
that x equals 0 on the standard network interface.
100