Lexmark X646ef Menus And Messages Manual page 115

Message
54 Network [x] software
error
54 Serial option [x]
error
54 Standard network
software error
55 Unsupported option in
slot [x]
56 Parallel port [x]
disabled
56 Serial port [x]
disabled
56 Standard parallel
port disabled
56 Standard USB port
disabled
Understanding MFP messages
Meaning
The MFP cannot establish
communications with a specified
installed network port. x indicates the
number of the specified port.
The MFP detects a serial error, such
as framing, parity, or overrun on the
specified optional serial port. x is the
number of the optional serial port.
The MFP firmware detects an
installed network port, but cannot
establish communication with it.
The MFP detects an unsupported
option in the specified slot. x indicates
the number of the specified slot.
A status request occurs over the
parallel port, but the parallel port is
disabled.
The MFP receives data across a
serial port, but the port is disabled.
The message appears when a status
is requested through the parallel port,
but the port is disabled.
The MFP receives data through a
USB port, but the USB port is
disabled.
Attendance messages
115
Action
• Touch Continue to clear the message and
continue printing. The job may not print
correctly.
• The MFP disables attempts to communicate
through the network interface. No data may
be sent or received.
• Reset the MFP.
• Program new firmware for the network
interface.
• Make sure the serial link is set up correctly,
and the appropriate cable is in use.
• Make sure the serial interface parameters
(protocol, baud, parity, and data bits) are set
correctly on the printer and host computer.
• Touch Continue to clear the message and
continue processing the print job; however
the print job may not print correctly.
• Turn the MFP off and then on to reset it.
• Touch Continue to clear the message and
continue printing. The job may not print
correctly.
• The MFP disables attempts to communicate
through the network interface. No data may
be sent or received.
• Reset the MFP.
• Program new firmware for the network
interface.
1 Turn the MFP off.
2 Unplug the power cord from the wall outlet.
3 Remove the unsupported option.
4 Connect the power cord to a properly
grounded outlet.
5 Turn the MFP on.
Touch Continue. The MFP discards any data
received on the parallel port.
Touch Reset Active Bin to reset the active bin
for a linked set of bins.
Touch Continue. The MFP discards any data
received on the serial port.
Touch Reset Active Bin to change to another
linked bin.
• Touch Continue to clear the message.
The MFP discards any data received through
the parallel port.
• Make sure the Parallel Buffer menu item is
not set to Disabled.
Touch Continue. The printer discards any data
received through the USB port.
Make sure the USB Buffer menu item is not set
to Disabled.
Touch Reset Active Bin to change to another
linked bin.