Install Handset Wall Holder - Valor RETROFIRE RF24IDN Installation And Owner's Manual

QUALIFIED
INSTALLER
Bottom Cover Installation
Important: When the bottom cover is used instead of a fret,
a space is required in front of the window to allow the window
to move and relieve during a hard start. It is therefore very
important to ensure that an area of 3/4 inch (19 mm) in
front of the window is kept clear at all times.
Hook the upper fl ange of the bottom
cover onto the window bolts.
Rear View
Top
Bottom

Install Handset Wall Holder

The remote control kit for this fi replace
comes complete with a wall-mounted holder.
This holder is not required in all installations
but is provided as an optional feature for
those customers who wish to mount the
remote handset to the wall.
To install the holder to the wall, fi nd a
convenient location and use the hardware
provided with the kit. See the diagram below
for required hardware and confi gurations.
Note that the holder can be installed at the
base of a light switch plate.
IMPORTANT. The location of the remote
control handset is important to assure proper
temperature regulation. To obtain a constant temperature, we recommend that the handset should be between 3
and 15 feet away from the appliance but not directly above it. We also advise that the handset should be located
away from any other heat source and not in direct sunlight as this may affect the temperature sensor located in the
remote handset.
30
Installation
Top flange
Side View
Front
Bottom flange
(bends here)
1 Wall Bracket A
2 Screws B
1 Screw C
2 Wall Anchor D
1 Spacer E
(detach before assembly)
1 Wall Bracket F
An area of 3/4 inch (19 mm) in front of the
window MUST be kept clear at all times!
DO NOT use
this hole
Top
Rear
Bottom
(end plates longer
than front plate
at bottom)
Alternative 2
Packing Contents:
Alternative 1
Hook the top
flange of the
bottom cover
to the window
retaining pins
Alternative 3
Switch Plate