Displaying Port Members Of Multicast Groups; Figure 3-141 Mvr Port Information - Edge-Core ES3510 Management Manual

3
Configuring the Switch
• MVR Status – Shows the MVR status. MVR status for source ports is "ACTIVE" if
MVR is globally enabled on the switch. MVR status for receiver ports is "ACTIVE"
only if there are subscribers receiving multicast traffic from one of the MVR groups,
or a multicast group has been statically assigned to an interface.
• Immediate Leave – Shows if immediate leave is enabled or disabled.
• Trunk Member
Web – Click MVR, Port or Trunk Information.
CLI – This example shows information about interfaces attached to the MVR VLAN.
Console#show mvr interface
Port Type
------- -------- ------------- ---------------
eth1/1 SOURCE
eth1/2 RECEIVER ACTIVE/UP
Console#

Displaying Port Members of Multicast Groups

You can display the multicast groups assigned to the MVR VLAN either through
IGMP snooping or static configuration.
Field Attributes
• Group IP – Multicast groups assigned to the MVR VLAN.
• Group Port List – Shows the interfaces with subscribers for multicast services
provided through the MVR VLAN.
13. Port Information only.
3-222
13
– Shows if port is a trunk member.

Figure 3-141 MVR Port Information

Status Immediate Leave
ACTIVE/UP Disable
Disable
4-294