Smtp Alert Commands; Logging Sendmail Host; Table 4-22 Smtp Alert Commands - Edge-Core ES3510 Management Manual

4
Command Line Interface
Example
The following example shows sample messages stored in RAM.
Console#show log ram
[5] 00:01:06 2001-01-01
"STA root change notification."
level: 6, module: 6, function: 1, and event no.: 1
[4] 00:01:00 2001-01-01
"STA root change notification."
level: 6, module: 6, function: 1, and event no.: 1
[3] 00:00:54 2001-01-01
"STA root change notification."
level: 6, module: 6, function: 1, and event no.: 1
[2] 00:00:50 2001-01-01
"STA topology change notification."
level: 6, module: 6, function: 1, and event no.: 1
[1] 00:00:48 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 6, function: 1, and event no.: 1
Console#

SMTP Alert Commands

These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
Command

logging sendmail host

logging sendmail level
logging sendmail
source-email
logging sendmail
destination-email
logging sendmail
show logging sendmail
logging sendmail host
This command specifies SMTP servers that will be sent alert messages. Use the no
form to remove an SMTP server.
Syntax
[no] logging sendmail host ip_address
ip_address - IP address of an SMTP server that will be sent alert
messages for event handling.
Default Setting
None
4-58

Table 4-22 SMTP Alert Commands

Function
SMTP servers to receive alert messages
Severity threshold used to trigger alert messages
Email address used for "From" field of alert messages
Email recipients of alert messages
Enables SMTP event handling
Displays SMTP event handler settings
Mode Page
GC 4-58
GC 4-59
GC 4-60
GC 4-60
GC 4-61
NE, PE 4-61