Configuring Private Vlan Interfaces; Figure 3-101 Private Vlan Port Information - Edge-Core ES3510 Management Manual

Web – Click VLAN, Private VLAN, Port Information or Trunk Information.
CLI – This example shows the switch configured with primary VLAN 5 and
community VLAN 6. Port 3 has been configured as a promiscuous port and mapped
to VLAN 5, while ports 4 and 5 have been configured as host ports and associated
with VLAN 6. This means that traffic for port 4 and 5 can only pass through port 3.
Console#show vlan private-vlan
Primary Secondary
-------- -----------
5
5 6
Console#

Configuring Private VLAN Interfaces

Use the Private VLAN Port Configuration page to set the private VLAN interface
type, and assign the interfaces to a private VLAN.
Command Attributes
• Port – The switch interface.
• PVLAN Port Type – Sets the private VLAN port types.
- Normal – The port is not assigned to a private VLAN.
- Host – The port is a community port or an isolated port. A community port can
communicate with other ports in its own community VLAN and with designated
promiscuous port(s). An isolated port can only communicate with the single
designated promiscuous port in the isolated VLAN; it cannot communicate with
any other host ports.
- Promiscuous – A promiscuous port can communicate with all interfaces within
a private VLAN.

Figure 3-101 Private VLAN Port Information

Type Interfaces
---------- ------------------------------
primary Eth1/ 3
community Eth1/ 4 Eth1/ 5
VLAN Configuration
4-241
3-165
3