Advanced Menu → Communications - GE DSR-2000e User Manual

ADM Setting
99 Days
Advanced Menu → Communications
5.5
Use thus menu to specify:
• The data transfer rate for the RS-232 serial port.
• The units Ethernet network connection settings.
• The units Modem Settings.
Advanced Menu → Communications → Baud Rate
o
Use the Jog to select the Baud Rate.
Press the Enter button to confirm the selection and exit the menu.
Press the Menu button to exit the menu without making changes.
Advanced Menu → Communications → Ethernet Settings
o
An Ethernet session is an active network connection between a PC and the unit, with the user viewing
live camera images or accessing data stored on the hard disk.
When Ethernet is first selected,
this warning box will appear.
Select OK to continue.
Use this menu to configure the Ethernet communications settings. Select from the
following:
Hostname: Not selectable. Pulled from the systems serial number.
Ethernet: Select Enable or Disable.
DHCP: Select Enable or Disable. Enables dynamic IP addressing. When DHCP is enabled, the IP
address, Subnet Mask, Gateway, and Server fields are dynamically addressed.
Name Service: Select from Disable or WINS. Enabling WINS registers the hostname and IP address
within the current Network. This ensures that you can connect to the DSR by hostname within the
network.
ADM will change. Are you sure?
--OR—
Warning – Machine will reset if any values change!
Message
Yes
Baud Rate
Ethernet Settings
Modem Settings
Message
[OK]
1200 Baud
2400 Baud
4800 Baud
9600 Baud
19200 Baud
38400 Baud
57600 Baud