Table of Contents
Advertisement
IP Address / Subnet Mask / Gateway: Consult with a qualified Network Administrator or an MIS
professional to configure these settings if DHCP is not enabled.
Primary Name Server / Backup Name Server: The IP addresses of the Primary and Backup Name
Servers. Not required if DHCP is enabled.
Print Server: Enter the Print Servers IP address to enable the Print Image operation (Function and
Zoom).
TCP MTU Size: Select from Standard, 1400, and 1200. The MTU describes the maximum possible TCP
packet size. Standard (1500) is optimal for most ethernet network environments.
How the unit handles an Ethernet session
At the start of an Ethernet session, the unit locks out its own front panel and disables all RS-232 and
RS-485 communications. During the Ethernet session, the unit can only be accessed remotely, using
the WaveReader software. When the Ethernet session ends, the unit re-enables the RS-232 and RS-
485 communications and unlocks the front panel.
Playback stops when an Ethernet session is started. Playback will not be re-activated automatically
when the Ethernet session ends.
Advanced Menu → Communications → Modem Settings
o
The default modem string (shown below) is for use with Hayes Accura 56k, Diamond Supra Express
56k, and 5686 US Robotics modems in their default conditions. Consult with the modem manual
before attempting to make any changes. It is strongly recommended that the modem initialization
string only be modified by a qualified technician.
To enable modem communication select enable in the Modem Status field.
To modify the modem settings follow the steps below.
Ethernet Settings
Hostname
Ethernet
DHCP
Name Service
IP Address
Subnet Mask
Gateway
Primary Name Server
Backup Name Server
TCP MTU Size
[CANCEL]
: V201F04310209
:
Enable
: Disable
: Disable
:
3. 18.173. 60
: 255.255.254.
0
:
3. 18.172.
1
:
3. 18.173. 12
:
3. 18.173. 13
: Standard
[OK]
Advertisement
Table of Contents
