Table of Contents
Advertisement
3
Follow the instructions on the computer screen.
Changing wireless settings after installation (Windows users only)
To change your password, network name, or other wireless setting:
1
Click Programs or All Programs
2
Click Wireless Setup Utility.
Note: You may be prompted to connect the printer to the computer again using the installation cable as part of
the setup process.
3
Follow the prompts on the computer screen to reinstall the software, and make the changes you want.
Check printer ports (Windows users only)
Make sure the correct printer port is selected.
1
Click Start
Control Panel
2
Right-click Lexmark XXXX, where XXXX is the model series number of your printer.
3
Click Properties
Ports.
4
Verify that XXXX_Series_nnnnnn_P1 is selected, where XXXX is the model series number of your printer and
nnnnnn is the last six numbers of the MAC address of your printer.
Note: The MAC address is located at the back of the printer beside the serial number.
5
If USB is selected instead:
a
Select the port name from step 4.
b
Click Apply.
c
Close the window, and try printing again.
Print troubleshooting
Partial 4 x 6 in. (10 x 15 cm) photo prints when using a PictBridge-enabled
digital camera
Make sure paper size is set correctly
The printer issues the Paper or Photo Size Error when your chosen photo size does not match the paper
size that is set. This typically happens when you are trying to print from a PictBridge-enabled digital camera. You
may have left the printer control panel Photo Size menu item setting at 8.5 x 11" or 5 x 7" size, but your camera
setting has print size of 4 x 6" or L. You need to make sure your chosen photo size is 4 x 6" or 10 x 15 cm,
depending on the typically used photo size for your country or region.
•
Make sure the 4 x 6 in. (10 x 15 cm) photo paper is loaded correctly.
•
If your camera lets you change the print size setting, change the print size selection to 4 x 6 in. (10 x 15 cm) on
the PictBridge-enabled digital camera.
•
If your camera does not allow you to change the paper size setting, use the control panel to change the paper
size to 4 x 6 in. (10 x 15 cm).
1
Insert the USB cable that came with your camera to the camera, and insert the other end into the PictBridge
port on the front of the printer.
2
Turn the camera on and choose your first photo using the camera control panel.
3
Wait for the PictBridge Printing screen to appear on the printer control panel
Lexmark 7500 Series.
Printers.
159
Advertisement
Table of Contents
Troubleshooting
