Jump Start; Jump Start - Cushman 1600XD4 Owner's Manual

JUMP.START
(1) battery
if the battery is discharged and the
engine cannot be started, it is possi-
ble to start the engine by connecting
the discharged battery to a battery
from another vehicle or other extra
battery.
1. check that the voltage of the dis-
charged battery is the same as
the voltage of the other vehicle for
jump start (specification for this
vehicle: 12 V).
2. check the length of the jumper ca-
bles and position another vehi-
cle near the vehicle with the dis-
charged battery. then, put the
shift lever in the neutral position,
UUVO508A
apply the parking brake, and stop
the engine.
3. we a r p r o t e c t i v e g l a s s e s a n d
gloves and open the battery cover
of both vehicles. remove the bat-
tery terminal cover as necessary.
4. connect the alligator clips on both
ends of the red positive cable to
the positive terminals of both bat-
teries.
operation
5. connect one clip of the black
negative cable to the negative
terminal of the normal battery
and the other clip to the vehicle
body with the discharged battery.
make sure to connect the clip to
the body part without paint.
6. start the engine of the vehicle
with the normal battery.
7. start the engine of the vehicle
with the discharged battery.
8. Disconnect the black cable from
the negative battery terminals of
both of the vehicles.
9. Disconnect the red cable.
10. run the engine for at least 30
minutes to charge the discharged
battery.
11. if the battery is discharged again,
replace it or check the charging
system, such as the alternator.
5
-11
5