Using Biodiesel (Ak); Using Biodiesel (Ak); Adjusting Belt Tension (Al); Adjusting Belt Tension (Al) - Cushman 1600XD4 Owner's Manual

7
1600xD4
-0
3. unscrew nut 1 and adjust the
length of the shift cable.
4. unscrew nut 3 and adjust the
4WD cable.
5. to check 4WD operation, lift the
front and rear axles completely off
the ground and support with jack
stands.
6. start the engine and move the
2WD/4WD lever to "4WD" and
"2WD" positions to check rotation
of each wheel.
WARNING
Make sure that no one, espe-

cially children, near the vehi-
cle.

UsING BIoDIEsEl (Ak)

1. it is allowed to use 5% biodiesel
fuel. if biodiesel fuel of higher ratio
is used, the engine can be dam-
aged and this will not be covered
by warranty.
2. the biodiesel fuel should meet
a s t M D 6 7 5 1 , e N 1 4 2 1 4 a n d
equivalent standards.
3. for details about biodiesel use,
contact your Dealer.

ADJUsTING BElT TENsIoN (Al)

the engine belt drives the alterna-
tor and coolant pump. if the tension
of this belt is below the specification,
the alternator efficiency decreases,
resulting in insufficient battery charge
level and low coolant circulation effi-
ciency.
if the tension of this belt is too high,
it wears rapidly and service life of the
coolant pump bearing is shortened.
NoTE
in this vehicle, the electric fan is

not installed to the engine, but to
the radiator under the hood.
1. park the vehicle on level ground
and apply the parking brake firmly.
2. stop the engine and remove the
engine inspection shield and seat
cushion