Checking Fuel Filter(L); Checking Fuel Filter(L); Bleeding Fuel Line (M); Bleeding Fuel Line (M) - Cushman 1600XD4 Owner's Manual

ChECkING fUEl fIlTER(l)

(1) fuel filter (2) Drain plug
1. Water and dust in fuel are accu-
mulated in the filter. remove the
plug from the bottom of the fuel fil-
ter to drain any impurities.
2. Tighten the filter with a hand (not
a tool) after drainage.
3. start the engine and check for fuel
leakage.
REplACING fUEl fIlTER
1. Wipe the surface of the fuel filter
clean.
2. unscrew the plug on the bottom of
the fuel filter to drain fuel.
3. Remove the fuel filter.
4. remove foreign materials, such
as dirt, thoroughly and replace the
fuel filter with a new one.
U12O760A
MaiNteNaNce

BlEEDING fUEl lINE (M)

(1) pump (2) air plug
1. Make sure that the amount of fuel
in the fuel tank is sufficient.
2. If there is air in the fuel filter, turn
the filter cock to the air side and
turn the ignition key to turn the
start motor. Then, the air in the fil-
ter port is discharged through the
bleeding hose as shown in the fig-
ure.
7
-17
U12O761A
7