Checking And Changing Gearbox Oil (S); Checking And Changing Gearbox Oil (S) - Cushman 1600XD4 Owner's Manual

7
1600xD4
-2
ChECkING AND ChANGING
GEARBoX oIl (s)
1. park the vehicle on level ground
and apply the parking brake firmly.
2. stop the engine and let the engine
cooled down sufficiently.
3. raise the cargo bed and support it
with the support rod.
(1) filler plug
4. clean around filler plug, then re-
move the filler plug.
5. check that the gearbox surface
is not hot. then, check the oil lev-
el and condition with a finger bent
slightly. if you cannot reach the oil,
it means the oil level is low. add oil
as needed to fill.
6. if the color or viscosity of the oil is
not normal or it is at the oil change
interval, change the oil.
(1) Drain plug
7. to change oil, place a container
UUVO734A
with wide opening under the drain
plug. then, remove the drain plug.
8. after draining all the oil, install the
drain plug firmly.
9. W h e n a d d i n g n e w o i l , a d d i t
through a long hose into the fill
plug location. fill till oil starts to
spill out of filler plug hole.
(1) funnel
UUVO735A
oil Capacity
10. check the oil level by performing
the step 5 in the previous page.
if the oil level is normal, install
the filler plug.
11. Wipe the gearbox and is sur-
rounding with a rag thoroughly.
12. test drive the vehicle for 5 to 10
minutes to check for leakage.
UUVO765A
0.2 u.s gal. (0.9 l)