Checking Cvt Driven Pulley Clutch Buttons(K); Checking Cvt Driven Pulley Clutch Buttons(K) - Cushman 1600XD4 Owner's Manual

7
1600xD4
-1
(1) ctv belt
8. Measure the width of the cvt
belt. replace it with a new one if it
has been used for more than 300
hours or its width is 1 in. (25 mm)
or less. for replacement, contact
your Dealer.
the width of a new belt is 29 mm

(1 9/64 in.). its max. speed re-
duction ratio is 3.55 while its min.
speed reduction ratio is 0.68. as-
suming that its width is reduced
to 1 in. due to wear, the speed
reduction ratio would be 3.22
and 0.76 respectively. there-
fore, the maximum speed would
UUVO721A
be reduced by 10% and the max.
torque at a low speed would be
reduced by 9%.
9. if foreign materials are caught in
the components such as the cvt
belt or cvt pulley or there is dust
inside the cvt cover, clean thor-
oughly with vaccum cleaner and
reassemble them.
IMpoRTANT
Never apply grease, oil, or sim-

ilar fluids on the surface of the
belt and pulley.
ChECkING CVT DRIVEN pUl-
lEy ClUTCh BUTToNs(k)
1. remove the relevant parts such
NoTE
(1) clutch button 1
2. check the cvt driven pulley clutch
3. if they should need replacement
4. if foreign materials are caught in the
as the cvt cover by following the
same procedure as for the cvt belt
service (see "checking cvt belt").
(2) clutch button 2
buttons (1 and 2) for wear.
due to excessive wear, contact your
Dealer.
components such as the cvt belt or
cvt pulley or there is dust inside the
cvt cover, clean thoroughly with vac-
cum cleaner and reassemble them.
UUVO722A