Using A Pictbridge-Enabled Digital Camera To Control Printing Photos; Printing Photos Using The Computer; Printing Photos Stored On A Memory Device Using Fast Pics - Lexmark 5400 Series User Manual

Using a PictBridge-enabled digital camera to control printing photos

You can connect a PictBridge-enabled digital camera to the printer, and use the buttons on the camera to select and print
photos.
1
Insert one end of the USB cable into the camera.
Note: Use only the USB cable that came with the digital camera.
2
Insert the other end of the cable into the PictBridge port on the front of the printer.
Notes:
•
Make sure the PictBridge-enabled digital camera is set to the correct USB mode. For more information, see the
camera documentation.
•
The printer recognizes one active media device at a time. If you insert more than one media device, a message
appears on the display prompting you to designate the device you want the printer to recognize.
•
If the PictBridge connection is successful, the following appears on the printer display: PictBridge camera
detected. Press
page 110.
3
Follow the instructions in the camera documentation to select and print photos.
Note: If the printer is turned off while the camera is connected, you must disconnect and then reconnect the camera.

Printing photos using the computer

Notes:
•
To print photos or images from a Web page, see "Printing photos or images from a Web page" on page 50.
•
To use advanced photo-editing options, see "Using the Photo Editor" on page 40.

Printing photos stored on a memory device using Fast Pics

1
Load paper. For best results, use photo or glossy paper with the glossy or printable side facing you. (If you are not
sure which side is the printable side, see the instructions that came with the paper.)
2
Insert a memory card or flash drive that contains images you want to print. For more information, see "Inserting a
memory card" on page 53 or "Inserting a flash drive" on page 54.
The Fast Pics dialog appears.
3
From the dialog that appears, click on each photo that you want to print.
to change settings. If any other message appears, see "Error messages" on
59