Installing another language control panel
These instructions apply only if you received one or more additional language control panels with the printer.
1
Lift and remove the control panel (if one is installed).
2
Choose the correct control panel for your language.
3
Align the clips on the control panel with the holes on the printer, and then press down.
Getting the printer ready to fax
CAUTION: Do not use the fax feature during a lightning storm. Do not set up this product or make any electrical or
cabling connections, such as the power supply cord or telephone, during a lightning storm.
Choosing a fax connection
You can connect the printer with equipment such as a telephone, an answering machine, or a computer modem. If problems
occur, see "Setup troubleshooting" on page 93.
Note: The printer is an analog device that works best when directly connected to the wall jack. Other devices (such as a
telephone or answering machine) can be successfully attached to pass through the printer, as described in the setup steps.
If you want a digital connection such as ISDN, DSL, or ADSL, a third-party device (such as a DSL filter) is required.
You do not need to attach the printer to a computer, but you do need to connect it to a telephone line to send and receive
faxes.
You can connect the printer to other equipment. See the following table to determine the best way to set up the printer.
Equipment
•
The printer
•
A telephone cord
•
The printer
•
A telephone
•
Two telephone cords
Benefits
Send and receive faxes without using a
computer.
•
Use the fax line as a normal telephone
line.
•
Send and receive faxes without using a
computer.
See this section
"Connecting directly to a telephone wall
jack" on page 16
"Connecting to a telephone" on
page 17
13