Lexmark 5400 Series User Manual page 44

Load up to
10 envelopes
25 sheets of labels
50 transparencies
Make sure
•
The print side of the envelopes faces you.
•
The stamp location is in the upper left corner.
•
The envelopes are designed for use with inkjet printers.
•
The envelopes are loaded in the center of the paper support.
•
The paper guides rest against the edges of the envelopes.
Warning: Do not use envelopes that have metal clasps, string ties, or metal
folding bars.
Notes:
–
Do not load envelopes with holes, perforations, cutouts, or deep
embossing.
–
Do not use envelopes that have exposed flap adhesive.
–
Envelopes require more drying time. Remove each envelope as it exits,
and allow it to dry to avoid ink smudging.
•
The print side of the labels faces you.
•
The top of the labels feeds into the printer first.
•
The adhesive on the labels does not extend to within 1 mm of the edge
of the label.
•
You use full label sheets. Partial sheets (with areas exposed by missing
labels) may cause labels to peel off during printing, resulting in a paper
jam.
•
The labels are loaded in the center of the paper support.
•
The paper guides rest against the edges of the labels.
Note: Labels require more drying time. Remove each sheet of labels as it
exits, and allow it to dry to avoid ink smudging.
•
The rough side of the transparencies faces you.
•
If the transparencies have a removable strip, each strip faces away from
you and down toward the printer.
•
The transparencies are loaded in the center of the paper support.
•
The paper guides rest against the edges of the transparencies.
Notes:
•
Transparencies with paper backing sheets are not recommended.
•
Transparencies require more drying time. Remove each transparency
as it exits, and allow it to dry to avoid ink smudging.
44
1
2