Panasonic WJ-NV300K Operating Instructions Manual page 21

Change the registered information [Registered information]
Click the [Setup >] button for "Registered information" on the [Camera registration] tab to display the following
items.
After editing the settings, click the [OK] button to save the settings and return to the [Camera registration] tab.
[Camera]
Up to 32 cameras can be connected. By registering
the license for additional cameras, the number of
cameras can be increased up to 16, 24, or 32.
(Default: 16 for WJ-NV300K, 9 for WJ-NV300K/G.)
[Model]
The model of a registered camera will be displayed.
(Blank: Camera is not registered)
Click the [C] button to select the camera model from
the camera categories. Refer to the "readme.txt" on
the provided CD-ROM for camera categories.
It is unnecessary to change it for normal use.
[Address]
An address already in use will be displayed. The
address can be changed using the on-screen key-
board (☞ page 10). Enter up to 255 alphanumeric
characters including hyphens (-) and periods (.).
Note:
• Entering "http://" is not necessary if the host name
is entered.
[Compression]
Select the image compression method.
H.264/ MJPEG
Note:
• When selecting "MJPEG" for "Compression", the
live image transmission rate and the frame rate
will be changed automatically to "5 ips". (☞ Page
39)
• When selecting "H.264" for "Compression", it will
become possible to select "XF" for the image
quality setting.
• Depending on the model of the camera, the cam-
era may reboot when the compression method is
changed. The reboot will be detected as a com-
munication error, but that is not a malfunction.
[User name]
Enter the user name for accessing the cameras and
logging in using the on-screen keyboard (☞ page 10).
Register the user name whose access level is
"Administrator".
[Password]
Enter the password to be used for the user whose
name has been registered as "User name" (☞ page
10). (Up to 32 alphanumeric characters)
[Port No.]
Set a port number from 1 - 65535 for use by the cam-
era.
Default: 80
[Table to delete]
To delete registration information or remove a previ-
ously connected camera, either select the camera
number and click the [Delete] button, or set the IP
address of the respective camera to
"000.000.000.000".
Note:
• Enter the port number in five digits, right aligned.
(Example: When the port number is 80, enter
"00080".) The leading zeros are omitted here.
21