Panasonic WJ-NV300K Operating Instructions Manual page 27

Set the camera image transmission priority [Transmission priority]
Select the transmission priority setting for each camera and transmit the information to the cameras to change
the camera settings.
Clicking the [Setup >] button for "Transmission priority" on the [Camera setup] tab will display the setup page.
[Transmission priority]
Select the transmission mode for H.264 images from
the following.
The "Transmission priority" will be configured based
on the markings of the checkboxes of "H.264(1)" and
"H.264(2)".
Frame rate: H.264 images will be transmitted with
the frame rate specified in "Frame rate".
Advanced VBR: H.264 images will be transmitted
with the frame rate specified in "Frame rate".
When this parameter is selected, this product
transmits images while adjusting the average
of transmission amount in the period specified
in "Control time period" to match it to the
specified bit rate.
[Burst tolerance level]
Select the allowance of "Max bit rate (per client)" for
the H.264 bit rate from the following.
High, Middle, Low
[Control time period]
Select the period of controlling H.264 bit rate to be
recorded from the following.
1 h, 6 h, 24 h, 1 week
■ Camera Selection
Select the camera to which the setting of the "Trans-
mission priority" is to be sent.
Mark the checkbox of the camera to which the setup
information is to be transmitted.
[Transmission] button
Transmit the setting of the "Transmission priority" to
the camera.
Once transmission is completed and the setting has
been applied to the camera, "OK" will be displayed in
the "Results" field.
If the display reads "Authentication error", etc., the
camera connection or the setting may have failed.
[Back] button
Click the button after completing the settings.
The screen returns to the [Camera setup] tab.
27