Maintenance; Every Sixth Months; Service Contract; Ordering Numbers - Kemppi MASTER MLS 1600 Operation Instructions Manual

4. MAINTENANCE

Watch out for mains voltage when handling electric cables!
In planning product maintenance machine utilization degree and circumstances should be
considered. Careful use and preventive maintenance help to avoid unnecessary production
disturbances and breaks. Check the condition of the welding and connection cables daily. Do not
use damaged cables.
4.1. MAINTENANCE

4.1.1. Every sixth months

NOTE! Disconnect the plug of the machine from the mains socket and wait for ca. 2 minutes
(capacitor charge) before removing the casing plate.
The following maintenance operations should be carried out at least every sixth
months:
The electric connections of the machine - clean any oxidized parts and tighten any loose

ones. NOTE! You must know the correct tension torques before you start to repair the
connections.
Clean the inner parts of the machine from dust and dirt e.g. with a soft brush and a vacuum-

cleaner. Do not use pressurized air, because there is the danger that the dirt is packed even
more tightly in the gaps of the cooling profiles. Do not use a pressure washing device.
Only an authorized electric shop or electrician may repair the machine.

4.1.2. Service contract

KEMPPI -service workshops make special service contracts with customers about regular
maintenance. All parts are cleaned, checked and if necessary, repaired. Also the operation of
welding machine is tested.

4.2. ORDERING NUMBERS

MASTER MLS™ 1600
Welding cable 25mm², 5 m
Earth cable 25mm², 5 m
MASTERTIG MLS™ 2000
Torches:
TTC 160 4m
TTC 160 8m
TTC 160 16m
TTC 220 4m
TTC 220 8m
TTC 220 16m
Earth cable 25mm², 5 m
Gas flow meter AR/clock
Panels
MEL, MMA
MTL, TIG
MTX, TIG 4T-LOG
© KEMPPI OY
6102160
6184201
6184211
6112200
627016004
627016008
627016016
627022004
627022008
627022016
6184211
6265136
6106000
6116000
6116005
MASTER MLS™ 1600, MASTERTIG MLS™ 2000 / 0530 – 15