Combustion Chamber And Burner Pot Cleaning; Cleaning The Thermocontrol Sensor And Down Chute - Windhager BioWIN 2 Operating Manual

3. Care, cleaning and maintenance

3.6 Combustion chamber and Burner pot cleaning

Attention!
Do not open the combustion chamber door during operation. Always switch the boiler off first with
the ON/OFF button and wait until burnout mode has finished – Fig. 141. It is essential to let the
combustion chamber cool down before cleaning.
Attention!
Before cleaning with a vacuum cleaner, check that there are no longer any embers in the combus-
tion residue!
– Open cladding door and combustion chamber door – Fig. 142 – see section 2.1.
Fig. 141 Switching off BioWIN 2

3.6.1 Cleaning the thermocontrol sensor and down chute

– If necessary, remove fly ash from the thermocontrol sensor. The thermocontrol sensor is located in the com-
bustion chamber – Fig. 143.
– If necessary, use screwdriver to clean inside of down chute – Fig. 144.
– Remove combustion residue from the combustion chamber with a vacuum cleaner – Fig. 145.
Fig. 143 Cleaning the thermocontrol sensor
Fig. 145 Remove residue from combustion
from the combustion chamber
Fig. 142 Open cladding door and combustion chamber
door
Fig. 144 Cleaning the down chute
52