Assembling the Support Frame
Installation on Flat Roofs
or Freestanding Installation
1. Install both mounting rails
clamping brackets
as shown, then
tighten.
2. Install the connection housing
the retaining plates
and clamping
brackets
as shown, then tighten.
IMPORTANT
The tube holders on the installation rails
must be in alignment with those in the
connection housing; align with string if
necessary.
3. Where several collectors are installed
side-by-side, continue with "Joining
the Connection Housings" on page
42, otherwise continue with
"Installing the General Connection Kit
and Temperature Sensor" on page
43.
to the
to
35