Safety, Installation And Warranty Requirements - Viessmann VITOSOL 200-T SD2A 2m2 Series Installation Instructions Manual

Safety

Safety, Installation and Warranty Requirements

Please ensure that these instructions are read and understood before commencing installation. Failure to comply with the
instructions listed below and details printed in this manual can cause product/property damage, severe personal injury, and/or
loss of life. Ensure all requirements below are understood and fulfilled (including detailed information found in manual
subsections).
H Licensed professional heating
contractor
The installation, adjustment, service,
and maintenance of this equipment
must be performed by a licensed
professional heating contractor.
Please see section
"
entitled "Important
Regulatory and
Installation
Requirements".
H Product documentation
Read all applicable documentation
before commencing installation. Store
documentation near boiler in a readily
accessible location for reference in
the future by service personnel.
" For a listing of
applicable literature,
please see section
entitled "Important
Regulatory and Safety
Requirements".
H Advice to owner
Once the installation work is
complete, the heating contractor must
familiarize the system
operator/ultimate owner with all
equipment, as well as safety
precautions/requirements, shut-down
procedure, and the need for
professional service annually.
H Warranty
Information contained in
this and related product
documentation must be
read and followed. Failure
to do so renders warranty
null and void.
2
H Grounding/Lightning protection of the
solar system
In the lower part of the building,
install an electrical conductor on the
piping system of the solar circuit in
compliance with local regulations.
Connection of the solar system to a
new or existing lightning protection or
the provision of local grounding should
only be carried out by a licensed
professional, who must take into
account the prevailing conditions on
site.
CAUTION
Observe maximum load and distance
from edge before installing the
substructure to the roof. If necessary,
consult with a structural engineer to
determine if the structure is suitable
for installing solar collectors. The
collectors must be securely mounted
so that the mountings can withstand
intense wind conditions and local
snow loads.
CAUTION
Gloves and eye protection must be
worn when handling solar panels.
CAUTION
Solar panel connection pipes and
solar heating fluid can become hot
enough to cause severe burns.
Extreme caution must be taken if
panels have been in a stagnant
condition (no flow of fluid).
CAUTION
Avoid scratching or sudden shocks to
glass cover of the solar panel.
CAUTION
Never step on collectors or solder in
close proximity to the glass surface
of the solar panel.
H Applicability
Vitosol solar collectors are designed
for use in closed loop heating systems
for domestic hot water heating, space
heating and pool heating via a heat
exchanger. The use of Viessmann
heat transfer medium "Tyfocor-HTL"
is strongly recommended.
IMPORTANT
Pool water or potable water cannot be
pumped directly through the Vitosol
collectors. Damage to collectors caused
by corrosion or scaling will void
warranty.